Citroën Spacetourer: How To Reset Tyre Pressure Light (2016-2021)

Last Updated on January 19, 2021 by Nick

Citroën Spacetourer: How To Reset Tyre Pressure Light (2016-2021) – The Citroën Spacetourer is a van from the French car manufacturer Citroën presented at the Geneva Motor Show in March 2016. The model is largely identical to the Peugeot Traveler, the Toyota ProAce Verso and the Opel Zafira Life.

In the model hierarchy, the Spacetourer also replaces the Citroën C8, which was no longer produced in 2014. The Traveler replaces the Peugeot 807, which was also discontinued in 2014, while the Zafira Life also replaces the Opel Zafira C, which was produced until 2019.

Citroën Spacetourer: How To Reset Tyre Pressure Light (2016-2021)

Citroën Spacetourer: How To Reset Tyre Pressure Light (2016-2021)

The tyre pressure system must be initialized after an adjustment to the pressure of tyres, and after changing one or more wheels. Depending on your vehicle trim level, here are a few ways to reset the tyre under-inflation detection system on 2016 2017 2018 2019 2020 2021 Citroën Spacetourer:

With TPMS Button

Time needed: 7 minutes

Follow the instructions below if your vehicle is equipped with a Tyre Pressure Set button. Follow these steps to get started:

  1. Stop the vehicle and turn off the engine

    Tire pressure reset process cannot be done while the vehicle is moving.

  2. Adjust the cold tire pressure in all four tires recommended on the tire placard

    The tire placard located on the door panel

  3. Turn the ignition key to the “ON” position without starting the engine

    If your vehicle has an ignition button, press the START/STOP button without touching the brake pedal

  4. Look for the Tyre Pressure Set button and then press it for 3 seconds

    An audible signal will confirm that the sensor has been reset
    audi tpms tire pressure light reset

With Audio Display

  • Stop the vehicle and adjust the tire inflation pressure recommended on the tire placard
  • Turn ON the ignition without starting the engine
  • Press the MENU button at the bottom of the audio display
  • Go to the CONFIGURATION menu by using the ⏪ or ⏩ button
low tyre pressure light reset
  • Press the OK button to enter the menu
  • Select the Define The Vehicle Parameters
  • Select the Driving Assistance
  • Select the Tyre Pressure
  • Select the Reinitialisation
  • When a confirmation message appears, select YES to execute the TPMS reset

With Touchscreen

  • Make sure you have adjusted the tyre pressure recommended on the tire placard
  • Turn ON the ignition without starting the engine
  • Press the DRIVING / VEHICLE button
tpms tire pressure light reset
  • Select Under-inflation initialisation in the Driving Functions tab menu
  • Select Yes to execute the tyre pressure reset

These instructions are based on the Citroën Spacetourer owner’s manual. This procedure should apply to the third generation of the Citroën Spacetourer (2016 2017 2018 2019 2020 2021 model years). Hopefully, the article Citroën Spacetourer: How To Reset Tyre Pressure Light (2016-2021) can solve your problem. Good Luck!