2012-2017 Audi S8 Inspection Due Light Oil Change Minder Reset
|Last Updated on April 13, 2020 by Nick
2012-2017 Audi S8 Inspection Due Light Oil Change Minder Reset – In September 2011, the third generation of the Audi S8 was shown at the IAA in Frankfurt, which went on sale in April 2012. Instead of a naturally aspirated V10 engine like the predecessor, a new 4.0-liter V8 with Biturbo charging is now used.
Compared to the predecessor, the driving performance has also improved; from 0 to 100 km/h, the new Audi S8 should take 4.2 seconds. The cylinder deactivation in the partial-load range is intended to reduce fuel consumption and pollutant emissions, and Audi specifies the average fuel consumption as 10.1 l Super per 100 km.
2012-2017 Audi S8 Inspection Due Light Oil Change Minder Reset
Time needed: 7 minutes
When engine oil service is due, the Oil Change warning light will appear on the display. The service interval must be reset after performed the maintenance service or change the engine oil on your vehicle. Follow the instructions below to reset the Oil Change Light on your Audi S8:
- Turn ignition switch to ON position but do not start the engine
If your vehicle has an ignition button, press the START-STOP ENGINE button without touching the brake pedal.
- Press the CAR button on the MMI controls to access the vehicle menu
The button is located on the center console
- Select SERVICE & CONTROL
On some vehicle, you should select SERVICE & CHECKS
- Select “SERVICE & CHECKS”
Use the MMI control button to enter the menu
- Scroll down and select “SERVICE INTERVAL”
Use the MMI control button to enter the menu
- Scroll down and select RESET OIL CHANGE INTERVAL
Use the MMI control button to enter the menu
- When a message appears on the display, select YES to confirm
Done!
These instructions are based on the Audi owner’s manual. This procedure should be work on the third generation of Audi S8 (2012 2013 2014 2015 2016 2017 model years). Hopefully, the article of 2012-2017 Audi S8 Inspection Due Light Oil Change Minder Reset useful for you. Good Luck!