2008-2009 Mercury Sable Oil Life Light Oil Change Required Minder Reset – The Mercury Sable was originally put on the market as a middle class but eventually grew into a car in the upper-middle-class segment. The Sable was put on the market in 1992 by Ford Motor Company as a slightly more expensive Ford Taurus, with a little more luxury. The model was a hit for both the Mercury brand and the American car industry. In the twenty years that this car is on the market, almost 2 million copies have been sold.
The model was as futuristic during the introduction of the model, the press as soon wrote that this car came from the moon, especially the lightbar between the two headlights did call. The light bars are copied by other brands in the early nineties, and they came back in-house at the Villager. Since its introduction in 1986, a total of five generations have been on the market of this type.
2008-2009 Mercury Sable Oil Life Light Oil Change Required Minder Reset
Time needed: 7 minutes.
If the engine oil life is less than 10%, the Oil Change Required Light will appear on the display. The engine oil life interval must be reset after performed the maintenance service on your vehicle. Follow the instructions below to reset the Oil Change Required Light on your Mercury Sable:
- Turn the ignition key to the “ON” position
Don’t start the engine!
- Press the SETUP button repeatedly until you see “OIL LIFE = XXX% HOLD RESET = NEW”
The button is located on the steering wheel
- Press and hold the RESET button “OIL LIFE SET TO 100%” is displayed.
It will reset your oil life monitor and turn the change oil soon reading off.
- Turn the ignition off and then start the engine to verify the indicator has been reset
These instructions are based on the Mercury owner’s manual. This procedure should be work on the fifth generation of Mercury Sable (2008 2009 model years). Hopefully, the article of 2008-2009 Mercury Sable Oil Life Light Oil Change Required Minder Reset can solve your problem. Good Luck!