TPMS Reset: Ford Expedition Tire Pressure Sensor Light (2008-2020)

TPMS Reset: Ford Expedition Tire Pressure Sensor Light (2008-2020) – The Ford Expedition is a large upper mid-range off-road vehicle sold from 1997 to the present. The model of the American manufacturer Ford is only produced and sold in North America.

The third generation sold from 2007. This generation is available with a 5.4-liter V8 engine. The Ford Expedition is available with four-wheel drive and rear-wheel drive.

TPMS Reset: Ford Expedition Tire Pressure Sensor Light (2008-2020)

TPMS Reset: Ford Expedition Tire Pressure Sensor Light (2008-2020)

Time needed: 7 minutes.

Whenever tire pressure is adjusted, change a tire, or get it rotated you must carry out the TPMS reset procedure. You’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System on the Ford Expedition. Follow these steps to do it:

  1. Park your vehicle

    Stop the vehicle and turn off the engine

  2. Press and release the BRAKE pedal

    Ensure fully pressed!

  3. Without starting the engine, turn the ignition key from OFF to the ON position 3 times with the ending in the ON position

    If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position

  4. Press and release the BRAKE pedal

    Ensure fully pressed!

  5. Turn OFF the ignition

    Do not release the key!

  6. Turn the ignition key from OFF to the ON position 3 times with the ending in the ON position

    If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position

  7. You will hear a horn if you do it right

    The horn will sound twice and the TRAIN LEFT FRONT TIRE message will appear on the screen

  8. Start from the driver side front tire, use the TPMS Relearn tool to reset the tpms sensor

    Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor

  9. Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire

    A chirp horn will confirm that the sensor has been reset

  10. Turn off the ignition after you reset the last tire

    The TIRE LEARNING message will disappear

  11. Adjust the tire pressure in all four tires recommended on the tire placard

    Done!

These instructions are based on the Ford Expedition owner’s manual. This procedure should apply to the third generation of the Ford Expedition (2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article TPMS Reset: Ford Expedition Tire Pressure Sensor Light (2008-2020) can solve your problem. Good Luck!