How To Reset FTM Flat Tire Monitor Light on BMW M2 (2016-2020)
|Last Updated on January 28, 2021 by Nick
How To Reset FTM Flat Tire Monitor Light on BMW M2 (2016-2020) – The BMW M2 Coupé is a sports coupé and the highest-powered version of the BMW 2 series. This car is positioned below the M4 and above the BMW M240i.
In 2017 the 2 Series Coupés were facelifted. BMW changed the design of the front and rear lights. In the summer of 2018, with the introduction of the M2 Competition, there was a technical change in the engine of the M2; its engine output is 30 kW (40 PS) higher than the previous model.
How To Reset FTM Flat Tire Monitor Light on BMW M2 (2016-2020)
Time needed: 7 minutes
Each time a tire pressure has been adjusted or change the tire, you need to reset the Tire Pressure Monitor (TPM). Here is how to reset the FTM on BMW M2 (M235i M240i):
- Stop the vehicle
Turn off the engine and shift to neutral position or P position
- Adjust the cold tire pressure in all four tires recommended on the tire placard
The tire placard located on the door panel
- Press MENU button to enter the main menu
The button located on the center console
- Go to the MY VEHICLE
Use the dial navigation button to scroll the menu
- Select VEHICLE STATUS
Some menus will appear on the screen
- Select FLAT TIRE MONITOR
A confirmation message will appear
- Starting the engine
Put the key into the ignition slot, depress the brake pedal, and then press the START/STOP ENGINE button
- Select PERFORM RESET to execute the tire pressure reset
You can choose cancel to cancel it
- Drive the car
The system reset is completed while the car is on the move
These instructions are based on the BMW M2 owner’s manual. This procedure should apply to the first generation of BMW M2 (2016 2017 2018 2019 2020 model years). Hopefully, the article How To Reset FTM Flat Tire Monitor Light on BMW M2 (2016-2020) can solve your problem. Good Luck!