How To Reset Chevrolet Uplander TPMS Tire Pressure Sensor Light (2008) – The Chevrolet Uplander is a van of the Chevrolet division of the US manufacturer General Motors with front or all-wheel drive. It was only offered in North America.
It was built in the Doraville Assembly in Doraville near Atlanta, the capital of the US state of Georgia. It replaced the Venture and Astro models. On November 21, 2005, GM announced that the plant would be closing in late 2008.
How To Reset Chevrolet Uplander TPMS Tire Pressure Sensor Light (2008)
Time needed: 7 minutes.
If you have a 2008 2009 Chevrolet Uplander, you can reset the TPMS by increasing or decreasing the tire pressure without using tools. Follow these instructions to get started:
- Turn the ignition key to the “ON” position without starting the engine
If your vehicle has an ignition button, press the Engine Start/Stop button without touching the brake pedal
- Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds
The horn will sound twice and the TIRE LEARNING ACTIVE message will appear indicating the TPMS matching process has started
- Activate the TPMS sensor
Start from the driver side front tire, remove the valve cap, and then increasing or decreasing the tire’s air pressure until a horn chirp sounds
- Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire
A horn chirp will confirm that the sensor has been reset
- Turn off the ignition after you reset the last tire
The TIRE LEARNING ACTIVE message will disappear
- Adjust the tire pressure in all four tires recommended on the tire placard
These instructions are based on the Chevy Uplander owner’s manual. This procedure should apply to the first generation of the Chevy Uplander (2008 2009 model years). Hopefully, the article How To Reset Chevrolet Uplander TPMS Tire Pressure Sensor Light (2008) can solve your problem. Good Luck!