How To Reset Roland DJ-808 DJ Controller To Its Factory Settings – In recent years, the worlds of the DJ and the Live performer have increasingly converged. Roland and Serato cleverly capitalize on this trend by bundling their specialties. So you no longer have to choose between spinning or performing live, with the Roland Serato DJ808 you can do both at the same time on one controller specially developed for this purpose.
In the middle of the controller, you will find a four-channel DJ mixer that can also be used stand-alone. Very useful if you want to combine your turntables or CDJs with the DJ-808. Each channel contains a 3-band EQ and a filter with four filter modes. On the sides of the mixer, you will find the two dual decks with which you can control two decks per side at the same time.
How To Reset Roland DJ-808 DJ Controller To Its Factory Settings
Time needed: 7 minutes.
The TR-S patterns and the system settings can be returned to their factory-set state. Follow the instructions below to reset your Roland DJ-808 DJ Controller:
- Turn on the unit
Make sure the unit is in on position
- Press and hold the BACK button and then press the POWER switch
The RST screen will appear on the display and the [START/STOP] button start flashing
- Press the START/STOP button to execute the reset
When the OK appears on the display, factory reset is complete
- Turn the unit off and then turn on again to verify the system has been reset
These instructions are based on the Roland owner’s manual. Hopefully, the article How To Reset Roland DJ-808 DJ Controller To Its Factory Settings can solve your problem. Good Luck!