How To Reset Fujifilm X-Pro3 Mirrorless Camera To Factory Settings

How To Reset Fujifilm X-Pro3 Mirrorless Camera To Factory Settings – Towards the end of 2019, camera manufacturers are competing to launch their new products. Fujifilm is no exception, which this week presents its sophisticated mirrorless camera. The product is the Fujifilm X-Pro3 which not only has excellent photography capabilities, but the body is also resilient because it has an outer layer of Duratec and titanium.

Fujifilm X-Pro3 uses a 26.1MP “X-TransTM * 2 CMOS 4” sensor and an “X-Processor 4” image processing engine, to ensure sharp levels of performance and image quality. The camera can work in conditions that are almost pitch black thanks to a combination of sensors and processors and new firmware, where AF phase detection works with -6EV lighting.

How To Reset Fujifilm X-Pro3 Mirrorless Camera To Factory Settings

How To Reset Fujifilm X-Pro3 Mirrorless Camera To Factory Settings

Time needed: 7 minutes.

There are several reasons you need to reset your Fujifilm X-Pro3 camera to factory settings, such as when you want to sell it or when a system error. In this article, we will provide information about resetting the shooting settings and all setup menu settings to their default values.

  1. Turn on your camera

    Make sure your camera has enough power

  2. Press the MENU/OK button to enter the main menu

    The button is located near the screen
    fujifilm settings reset

  3. Select tab by using focus stick

    Press the MENU/OK button to enter the menu

  4. On the USER SETTING menu, scroll down to RESET

    Press the MENU/OK button to enter the menu
    fujifilm settings reset

  5. On the RESET menu, you can choose SHOOTING MENU RESET or SET-UP RESET

    Highlight the desired option and then press MENU/OK button

  6. When a message appears on the display, select OK to execute the reset

    Done!

These instructions are based on the Fujifilm owner’s manual. Hopefully, the article How To Reset Fujifilm X-Pro3 Mirrorless Camera To Factory Settings can solve your problem. Good Luck!