TPMS Reset: Ford Crown Victoria Tire Pressure Sensor Light (2008-2011)

Last Updated on November 27, 2020 by Nick

TPMS Reset: Ford Crown Victoria Tire Pressure Sensor Light (2008-2011) – The Ford Crown Victoria or also known as the Crown Vic, was a full-size sedan for Canada, the US, and the Middle East market from the American carmaker Ford.

The Crown Victoria is used extensively in the United States by taxi companies and the police force. The Crown Victoria was also related to the Lincoln Town Car, Mercury Grand Marquis, and Mercury Marauder. However, the interior and exterior of these cars differed.

TPMS Reset Ford Crown Victoria Tire Pressure Sensor Light (2008-2011)

TPMS Reset: Ford Crown Victoria Tire Pressure Sensor Light (2008-2011)

Time needed: 7 minutes

Whenever tire pressure is adjusted, change a tire, or get it rotated you must carry out the TPMS reset procedure. You’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System on the Ford Crown Victoria. Follow these steps to do it:

  1. Park your vehicle

    Stop the vehicle and turn off the engine

  2. Press and release the BRAKE pedal

    Ensure fully pressed!

  3. Without starting the engine, turn the ignition key from OFF to the ON position 3 times with the ending in the ON position

    If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position

  4. Press and release the BRAKE pedal

    Ensure fully pressed!

  5. Turn OFF the ignition

    Do not release the key!

  6. Turn the ignition key from OFF to the ON position 3 times with the ending in the ON position

    If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position

  7. You will hear a horn if you do it right

    The horn will sound twice and the TRAIN LEFT FRONT TIRE message will appear on the screen

  8. Start from the driver side front tire, use the TPMS Relearn tool to reset the tpms sensor

    Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor

  9. Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire

    A chirp horn will confirm that the sensor has been reset

  10. Turn off the ignition after you reset the last tire

    The TIRE LEARNING message will disappear

  11. Adjust the tire pressure in all four tires recommended on the tire placard

    Done!

These instructions are based on the Ford Crown Victoria owner’s manual. This procedure should apply to the second generation of Ford Crown Victoria (2008 2009 2010 2011 model years). Hopefully, the article TPMS Reset: Ford Crown Victoria Tire Pressure Sensor Light (2008-2011) can solve your problem. Good Luck!