How To Reset Roland System-1m Plug-out Synthesizer To Default Settings

How To Reset Roland System-1m Plug-out Synthesizer To Default Settings – The launch of the Aira series brought a new and fresh look to the Roland range. The SYSTEM-1m is a semi-modular synthesizer with PLUG-OUT capacity and a unique design that allows it to be used as a Eurorack module, table synth, or 19 ”rack-mount unit.

The name already indicates it; the System-1m is a module version of the previously released System-1. Since (under the hood) the implementation is variable, the front panel consists of (targeted) controllers. Like the System-1, you control two oscillators, an LFO, a mixer (which also has a sub-oscillator and noise) and a filter. The lights that make the Aira series so recognizable are not missing on the System-1m.

How To Reset Roland System-1m Plug-out Synthesizer To Default Settings

Time needed: 7 minutes

There are several reasons you need to reset your Roland System-1m to factory settings, such as when you want to sell it or when a system error. Here’s how the settings stored in the unit can be restored to their default values.

Turn on the unit
Make sure the unit is in on position
Press and hold the WRITE button
The button is located on the MEMORY section
Press the LFO KEY TRIG button
The LFO KEY TRIG button will be flashing
Hold down the WRITE button again and then press the LFO KEY TRIG button
The entire panel display will flashes. When the flashing ends, the factory reset is completed.
Turn off the the power, and then turn on it again to verify the system is reset
Done!

These instructions are based on the Roland owner’s manual. Hopefully, the article How To Reset Roland System-1m Plug-out Synthesizer To Default Settings can solve your problem. Good Luck!

Yomita

Hi! Yomita here. Photographer and electrical device troubleshooter are some of my other interests. Writing and disseminating knowledge that helps people is something I like doing.

Next How To Reset Canon PowerShot G5 X Digital Camera To Factory Settings »

Previous « 2018-2020 Vauxhall Opel Combo Service Minder Spanner Light Reset

View Comments

John says:

May 14, 2023 at 4:16 pm

Hello Yomita I have a Roland system 1m that I purched from a person on Reverb My Roland system 1m led demo or what people call it (vegas mode) is not turning on I reset it to go on in 2 minuets but it does not work can you help thanks John ps this is the process i took LED DEMO: Hold down the [LPF TYPE] and turn the [SELECT] knob. Specifies the time (minute) until the LED DEMO is shown (PITCH ENV (IN) jack lit means +10). If this is set to “–,“ the LED DEMO is not shown.