2011-2020 Toyota Dyna Maintenance Required Light Reset

2011-2020 Toyota Dyna Maintenance Required Light Reset – Toyota Dyna is a light commercial vehicle or truck manufactured by Toyota. Dyna-shaped cabin COE (cab over engine) where the seating crew is above the engine and the front wheels. Dyna chassis is available with short and long chassis with 4-wheel and six-wheel. Specifically for the Japanese market, Toyota also sells the twin brother of Dyna named Toyoace. At Old Version, Toyota Dyna has a twin brother of Daihatsu, namely Daihatsu Delta. Now, Toyota Dyna has a twin brother of Hino, namely Hino Dutro.

Production and marketing of Dyna began in 1975 with the Dyna truck type BU in 1975, which later evolved in 1984 into Dyna Rino 115PS six tires and four tires with a cabin that resembles the shape of Daihatsu Delta. In 2002, Dyna models undergo massive changes through Dynasaurus, among others, the vehicle is equipped with a 4.000cc engine cabin shape which exactly matches the Hino Dutro and several variants ranging from small trucks, trucks economical, trucks sweating, fast trucks, as well as the gigantic truck. Dyna 115 ST models are offered in four tires, as well as three models of 6 tires 115ET, 125LT, and 125HT.

2011-2020 Toyota Dyna Maintenance Required Light Reset

2011-2020 Toyota Dyna Maintenance Required Light Reset

Time needed: 7 minutes.

When engine oil needs to replace, the MAINT REQD message will appear on the display. The engine oil maintenance data must be reset after performed the maintenance service or change the engine oil on your vehicle. Follow the instructions below to reset the Oil Maintenance Required Light on your Toyota Dyna:

  1. Turn the ignition key to the “ON” position without starting the engine

    If your vehicle has an ignition button, press the ENGINE START/STOP button twice without touching the brake pedal

  2. Press the ODOMETER/TRIP button repeatedly until you see “TRIP A” 

    The button is located on the instrument cluster
    toyota oil maint reqd reset button

  3. Next, turn the ignition “OFF”

    Make sure you are in TRIP A when turning off the ignition!

  4. Press and hold the ODOMETER/TRIP button, and turn the ignition key to the “ON” position

    If your vehicle has an ignition button, press the ENGINE START/STOP button twice without touching the brake pedal

  5. Continue to hold down the ODOMETER/TRIP button until “000000” MILES appears on the display and the maintenance light turns off.

    Done!

For more details, please watch the following video:

These instructions are based on the Toyota owner’s manual. This procedure should apply to the latest generation of the Toyota Dyna (2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 model years). Hopefully, the article of 2011-2020 Toyota Dyna Maintenance Required Light Reset useful for you. Good Luck!