How To Reset Ford Fusion TPMS Tire Pressure System Light (2010-2020)

How To Reset Ford Fusion TPMS Tire Pressure System Light (2010-2020) – The Ford Fusion is a medium-sized car in Ford’s middle class, mainly for the North American market. The Ford Fusion was launched in 2006 as the successor to the medium-sized fourth-generation Ford Taurus.

Since 2007, this car is also available in four-wheel drive. The Ford Fusion was also released as a slightly more luxurious Mercury Milan (up to and including 2010) and the luxurious Lincoln MKZ. The second-generation Lincoln MKT was released in 2013 with a new design.

Table of Contents

How To Reset Ford Fusion TPMS Tire Pressure System Light (2010-2020)
2010-2016 Models
2017-2020 Models
With Hazard Flasher
With Cluster Display

How To Reset Ford Fusion TPMS Tire Pressure System Light (2010-2020)

Whenever tire pressure is adjusted, change a tire, or get it rotated you must carry out the TPMS reset procedure. Depending on the vehicle model year you have, here are a few ways to reset the TPMS on Ford Fusion:

2010-2016 Models

Time needed: 7 minutes

You’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System on this model. Follow these steps to do it:

Park your vehicle
Stop the vehicle and turn off the engine
Press and release the BRAKE pedal
Ensure fully pressed!
Without starting the engine, turn the ignition key from OFF to the ON position 3 times with the ending in the ON position
If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position
Press and release the BRAKE pedal
Ensure fully pressed!
Turn OFF the ignition
Do not release the key!
Turn the ignition key from OFF to the ON position 3 times with the ending in the ON position
If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position
You will hear a horn if you do it right
The horn will sound twice and the TRAIN LEFT FRONT TIRE message will appear on the screen
Start from the driver side front tire, use the TPMS Relearn tool to reset the tpms sensor
Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor
Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire
A chirp horn will confirm that the sensor has been reset
Turn off the ignition after you reset the last tire
The TIRE LEARNING message will disappear
Adjust the tire pressure in all four tires recommended on the tire placard
Done!

2017-2020 Models

There are 2 ways to reset TPMS in this generation. Depending on your vehicle trim level, here are a few ways to reset the TPMS:

With Hazard Flasher

Drive your car for at least two minutes between 20 mph
Stop the vehicle and turn off the engine
Turn ON the ignition without starting the engine
Turn the hazard flashers ON then OFF 3 times within 10 seconds

If you successfully enter the reset mode, the horn will sound indicating the TPMS matching process has started
Start from the driver side front tire, remove the valve cap, and then increasing or decreasing the tire’s air pressure until a horn chirp sounds
A horn chirp will confirm that the sensor has been reset
Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire
Turn off the ignition after you reset the last tire
Adjust the tire pressure in all four tires recommended on the tire placard

With Cluster Display

Stop the vehicle and turn off the engine
Adjust the cold tire pressure in all four tires recommended on the tire placard
Turn the ignition key to the “ON” position without starting the engine
Go to the DRIVER ASSIST menu by using the ▲▼ navigation button

Press the OK button to select
Scroll down and select TIRE MONITOR
Press and hold the OK button until a confirmation message appear on the screen

These instructions are based on the Ford Fusion owner’s manual. This procedure should apply to the first and second generations of Ford Fusion (2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 model years). Hopefully, the article How To Reset Ford Fusion TPMS Tire Pressure System Light (2010-2020) can solve your problem. Good Luck!

Nick

Hi! Greetings, I'm Nick, an automotive technician and a vehicle enthusiast with over a decade of experience working at a dealer service station. I have extensive knowledge of engine oils and lubricants and have helped countless customers maintain their vehicles. As an editor and author of articles on automobiles, I draw on my personal experience and professional training to provide readers with accurate and reliable information. I am passionate about sharing my expertise with others and helping them make informed decisions about their vehicles.

Next Ford Mustang: How To Reset TPMS Low Tire Pressure Light (2007-2021) »

Previous « TPMS Reset: 2017-2021 Ford GT Low Tire Pressure Sensor Light

Published by

Nick

Tags: 2010 Ford FusionFord Fusion Tire PressureFord Fusion TPMS ResetFusion Tire Pressure ResetFusion Tire System ResetFusion TPMS Light Reset

4 years ago