How To Reset Chevy City Express Tire Pressure Sensor TPMS Light (2015-2018)

Last Updated on October 25, 2020 by Nick

How To Reset Chevy City Express Tire Pressure Sensor TPMS Light (2015-2018) – In May 2013, Nissan signed a deal with General Motors. Nissan then produced the NV200 as the Chevrolet City Express, also using badge engineering, which Chevrolet sold from 2014 to 2018 in the USA and Canada.

The production was stopped due to small numbers. Overall, the “City Express” sold less than 30,000 units in the USA.

How To Reset Chevy City Express Tire Pressure Sensor TPMS Light (2015-2018)

How To Reset Chevy City Express Tire Pressure Sensor TPMS Light (2015-2018)

If you replacing a spare tire with a road tire containing the TPMS sensor on your Chevrolet City Express, the system will detect a malfunction and the low tire pressure warning light will blink. When that happens, the TPMS sensor reset process must be done. Depending on the vehicle model you have, here are a few ways to reset the TPMS.

With RKE

Time needed: 7 minutes

If you have 2015 2016 2017 2018 Chevrolet City Express, you’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System. Follow these instructions to get started:

  1. Turn the ignition key to the “ON” position without starting the engine

    If your vehicle has an ignition button, press the Engine Start/Stop button without touching the brake pedal

  2. Press the Remote Keyless Entry (RKE) transmitter’s LOCK and UNLOCK buttons simultaneously for five seconds

    The horn will sound twice and the TIRE LEARNING ACTIVE message will appear indicating the TPMS matching process has started
    chevrolet tpms light reset

  3. Activate the TPMS sensor

    Start from the driver side front tire, place the TPMS Relearn Tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor

  4. Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire

    A horn chirp will confirm that the sensor has been reset

  5. Turn off the ignition after you reset the last tire

    The TIRE LEARNING ACTIVE message will disappear

  6. Adjust the tire pressure in all four tires recommended on the tire placard

    Done!

With DIC Button

Just like the previous model, you’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System in this model. Here’s how to do it:

  • Turn the ignition key to the “ON” position without starting the engine
  • Press the VEHICLE INFORMATION button briefly until you see the PRESS ✓ TO RELEARN TIRE POSITIONS message on the display
chevrolet oil tpms light reset
  • Press and hold the ✓ button until the horn sounds twice
  • Start from the driver side front tire, place the TPMS Relearn Tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor
  • Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire
  • Turn off the ignition after you reset the last tire
  • Adjust the tire pressure in all four tires recommended on the tire placard

These instructions are based on the Chevy City Express owner’s manual. This procedure should apply to the first generation of the Chevy City Express (2015 2016 2017 2018 model years). Hopefully, the article How To Reset Chevy City Express Tire Pressure Sensor TPMS Light (2015-2018) can solve your problem. Good Luck!