2014-2021 Peugeot 301 Tyre Pressure Sensor Light Reset Guide
Last Updated on December 17, 2020 by Nick
2014-2021 Peugeot 301 Tyre Pressure Sensor Light Reset Guide – The Peugeot 301 is a Peugeot car type and was produced between 1932 and 1936. This car was re-introduced in 2012, together with the return of the Citroën Elysée.
This vehicle is the beginning of a new categorization of Peugeot models. In Europe, the model will be offered from November 2012 in Turkey and later in Southern and Eastern Europe, but not in Western Europe.
Table of Contents
2014-2021 Peugeot 301 Tyre Pressure Sensor Light Reset Guide
The tyre pressure system must be initialized after an adjustment to the pressure of tyres, and after changing one or more wheels. Depending on your vehicle trim level, here are a few ways to reset the tyre under-inflation detection system on Peugeot 301:
With TPMS Button
Time needed: 7 minutes
Follow the instructions below if your vehicle is equipped with a Tyre Pressure Set button. Follow these steps to get started:
- Stop the vehicle and turn off the engine
Tire pressure reset process cannot be done while the vehicle is moving.
- Adjust the cold tire pressure in all four tires recommended on the tire placard
The tire placard located on the door panel
- Turn the ignition key to the “ON” position without starting the engine
If your vehicle has an ignition button, press the START/STOP button without touching the brake pedal
- Open the glove box and then press the Tyre Pressure Set button for 3 seconds
An audible signal will confirm that the sensor has been reset
With Audio Display
- Stop the vehicle and adjust the tire inflation pressure recommended on the tire placard
- Turn ON the ignition without starting the engine
- Press the MENU button at the bottom of the audio display
- Go to the CONFIGURATION menu by using the ⏪ or ⏩ button
- Press the OK button to enter the menu
- Select the Define The Vehicle Parameters
- Select the Driving Assistance
- Select the Tyre Inflation
- Select the Reinitialisation
- When a confirmation message appears, select YES to execute the TPMS reset
With Infotainment Display
- Make sure you have adjusted the tyre pressure recommended on the tire placard
- Turn ON the ignition without starting the engine
- Press the MENU button
- Select the DRIVING menu by tap the screen
- Select Under-Inflation Initialisation
- Select Yes to execute the tyre pressure reset
These instructions are based on the Peugeot 301 owner’s manual. This procedure should apply to the first generation of the Peugeot 301 (2014 2015 2016 2017 2018 2019 2020 2021 model years). Hopefully, the article 2014-2021 Peugeot 301 Tyre Pressure Sensor Light Reset Guide can solve your problem. Good Luck!
About The Author
Nick
Hi! Greetings, I'm Nick, an automotive technician and a vehicle enthusiast with over a decade of experience working at a dealer service station. I have extensive knowledge of engine oils and lubricants and have helped countless customers maintain their vehicles. As an editor and author of articles on automobiles, I draw on my personal experience and professional training to provide readers with accurate and reliable information. I am passionate about sharing my expertise with others and helping them make informed decisions about their vehicles.
