How To Reset Saturn Relay Oil Life Light Change Oil Minder (2005-2007)
|Last Updated on April 13, 2020 by Nick
How To Reset Saturn Relay Oil Life Light Change Oil Minder (2005-2007) – The Saturn Relay was an MPV produced by General Motors. It was introduced for the 2005 model year and was built with its clones Buick Terraza, Chevrolet Uplander and Pontiac Montana SV6 in Doraville, Georgia. Le Relay was the first Saturn vehicle with no plastic panels for bodywork, as well as the first returned Saturn and the first (and only) MPV produced by the brand.
The Relay began its career with a V6 3,5 L LX9 with a power of 200 horses and a couple of 300 Nm. It went from 0 to 96 km / h in about 9 seconds. For 2006, a 3.9L LZ9 V6 was introduced as an option, delivering a power of 240 horsepower and a torque of 332 Nm, with a better response time and a sharper acceleration compared to the 3.5L. This engine disappeared in 2007, replaced by the 3.9L which became the basic engine.
How To Reset Saturn Relay Oil Life Light Change Oil Minder (2005-2007)
Time needed: 7 minutes
When the remaining oil life is low, the Change Engine Oil Soon message will appear on the display. The Oil Life display must be reset after each oil change. Follow the instructions below to reset the engine oil life system on your Saturn Relay:
- Turn the ignition key to the “ON” position
Don’t start the engine!
- Press the ▲i▼ button repeatedly until you see Remaining Oil Life on the display
The button is located on the center console
- Press the ⏎ button for several seconds
Press and hold the ⏎ button until the Oil Life display changes to 100 percent
- Turn the ignition off and start the engine to verify the indicator has been reset
Done!
These instructions are based on the Saturn owner’s manual. This procedure should apply to the first generation of Saturn Relay (2004 2005 2006 2007 model years). Hopefully, the article on How To Reset Saturn Relay Oil Life Light Change Oil Minder (2005-2007) useful for you. Good Luck!