How To Reset Roland DJ-202 Serato DJ Controller To Factory Settings
|Last Updated on June 20, 2022 by Nick
How To Reset Roland DJ-202 Serato DJ Controller To Factory Settings – The Roland DJ-202 is a two-channel, four-deck USB bus-powered controller that can be transported and configured with minimal effort. ts practical handles and compact, lightweight design give DJs the portability they need for all kinds of events.
You can access the built-in 16-step sequencer through the performance pads and controls of the Serato DJ Lite sampler for jamming on the fly, and the controller also doubles as a USB audio / MIDI interface (24-bit fidelity / 48 kHz and high resolution digital to analogue converters). There’s even a MIDI output to control and sync external equipment, as well as a 1/4-inch mic input with gate, high pass, reverb, and echo.
How To Reset Roland DJ-202 Serato DJ Controller To Factory Settings
Time needed: 7 minutes
There are several reasons you need to reset your Roland DJ-202 to factory settings, such as when you want to sell it or when a system error. Here’s how the settings stored in the unit can be restored to their default values.
- Press and hold the LOAD button
The button is located on the browser section (L channel)
- Plug the USB cable to connect the device to your computer
Keep holding the LOAD button until the START/STOP button flashing
- Press the flashing START/STOP button to execute a reset
The MASTER level indicator will be flashing, and then all buttons and pads are lit. It indicates that the reset is complete
- After the reset is complete, disconnect the USB cable to power-off the device
Done!
These instructions are based on the Roland owner’s manual. Hopefully, the article How To Reset Roland DJ-202 Serato DJ Controller To Factory Settings can solve your problem. Good Luck!