How To Reset Lincoln Navigator Change Engine Oil Life Light (2008-2014) – The Lincoln Navigator is an SUV from Ford’s premium brand Lincoln. It is based on the Ford Expedition but is equipped with higher quality. Its direct competition consists of the Cadillac Escalade and the GMC Yukon. The third generation of Navigator was introduced in 2007. It is based on the Ford-T1 chassis that also has the Ford F-150 is based.
Completely redesigned visually, this model stands out clearly from its two predecessors. The most striking changes are the much more distinctive front end, with the huge chrome-colored grille, the redesigned headlamps and a “powerful” -looking bonnet. But the redesigned rear end is also significantly different from that of its predecessor. Also new are the many chrome parts, such as the chrome exterior mirrors or chrome-colored trim on the doors.
How To Reset Lincoln Navigator Change Engine Oil Life Light (2008-2014)
Time needed: 7 minutes.
If the engine oil life is less than 5%, the Oil Change Required Light will appear on the display. The engine oil life interval must be reset after performed the maintenance service on your vehicle. Follow the instructions below to reset the Change Engine Oil minder light on your Lincoln Navigator:
Turn the ignition to run, one position before starting the engine.
Press the SETUP button briefly to cycle to “OIL LIFE XXX% HOLD RESET = NEW”
The button is located on the center console
If you’re on that screen, press and hold the RESET button until “OIL LIFE SET TO 100%” is displayed.
Turn key off and then start your car and it should be reset.
For more details, please watch the following video:
This tutorial we got from the Lincoln owner’s manual. This procedure should apply to the third generation of the Lincoln Navigator (2008 2009 2010 2011 2012 2013 2014 model years). Hopefully, the article How To Reset Lincoln Navigator Change Engine Oil Life Light (2008-2014) can solve your problem. Good Luck!