How to Find Keyless Entry Door Factory Code on Ford Edge – The Ford Edge is an SUV D size crossover manufactured by Ford. It was officially presented at the 2006 Detroit Motor Show and released in December of that year. It uses the same platform as the Mazda 6, Ford Fusion, Mercury Milan, Lincoln MKZ, Lincoln MKX and Mazda CX-9. Edge is produced in Oakville, Canada. Its main competitors are the Chevrolet Equinox, Hyundai Santa Fe, Kia Sorento, Mazda CX-7.
The only engine is a six-cylinder petrol V, 3.5-liter, 289 hp maximum power. It is offered with a six-speed automatic gearbox and front-wheel drive or four-wheel drive unit. Ford Edge sales in the US have risen since its launch, surpassing all other major SUVs from January to June 2007, with more than 58,000 units sold.
How to Find Keyless Entry Door Factory Code on Ford Edge:
Have you lost your factory door code for your Ford car? This guide shows you how to find the Factory preset Ford Edge (2011 2012 2013 2014 2015 2016 2017 2018 model years) Keyless Entry Code.
The first thing to get Keyless Entry Door Factory Code you must have 2 keys do this
Insert the FIRST KEY in the ignition
If your vehicle equipped with a Start/Stop button, you need place the first intelligent access key into the backup slot inside the center console.
The key buttons should be facing the rear of your vehicle and the key ring up
Turn to the “on” position but do not start the engine (press the START/STOP button once), and wait about 4 seconds
Turn the ignition key to “OFF” position (Press the START/STOP button again)
Take out that key and then insert the SECOND KEY
Turn to the “on” position but do not start the engine, and wait until your factory code show up on the dash screen
The first thing to get Keyless Entry Door Factory Code you need to locate the Smart Junction Box (SJB).
Remote Keyless Entry (RKE) code located on a black & white sticker attached to the Smart Junction Box SJB, it is 5-digit followed by a letter.
On the 2010-2015 Ford Edge, the Smart Junction Box (SJB) is located in the behind a trim panel on the left side of the driver’s footwell. You will need to remove the trim panel, slide the release lever to the right then pull the trim panel out.
For the latest model of Ford Edge (2016 2017 2018), you may need a tool to see that code.
For more details, please watch the following video:
This procedure should work for the latest generation of the Ford Edge (2010 2011 2012 2013 2014 2015 2016 2017 2018 models). Hopefully, the article of How to Find Keyless Entry Door Factory Code on Ford Edge useful for you. Good Luck!