2019-2021 Ford Endura TPMS Tyre Pressure Sensor Light Reset Guide

Last Updated on December 2, 2020 by Nick

2019-2021 Ford Endura TPMS Tyre Pressure Sensor Light Reset Guide – The Ford Edge is a mid-size SUV from the American car manufacturer Ford. In mid-2018, the car hit the Australian market, where it was named Ford Endura.

The vehicle was preceded by a prototype presented at the 2013 Los Angeles Motor Show. The car was built on the 4th generation Ford Mondeo platform and will be positioned above the Ford Kuga.

2019-2021 Ford Endura TPMS Tyre Pressure Sensor Light Reset Guide

2019-2021 Ford Endura TPMS Tyre Pressure Sensor Light Reset Guide

Time needed: 7 minutes

Whenever tire pressure is adjusted, change a tire, or get it rotated you must carry out the TPMS reset procedure. Here is how to reset the TPMS on 2019 2020 2021 Ford Endura:

  1. Park your vehicle

    Stop the vehicle and turn off the engine

  2. Adjust the cold tire pressure in all four tires recommended on the tire placard

    The tire placard located on the door panel

  3. Turn the ignition key to the “ON” position without starting the engine

    If your vehicle has an ignition button, press the START/STOP button once without touching the brake pedal

  4. Press ◄ navigation button to enter the cluster menu

    The button is located on the steering wheel
    change engine oil life light reset

  5. Go to DRIVER ASSIST

    Use the navigation button to scroll and press OK to select

  6. Scroll down and select TYRE MONITOR

    Use the navigation button to scroll

  7. Press and hold the OK button until a confirmation message appear on the screen

    Done!

These instructions are based on the Ford Endura owner’s manual. This procedure should apply to the second generation of Ford Endura (2019 2020 2021 model years). Hopefully, the article 2019-2021 Ford Endura TPMS Tyre Pressure Sensor Light Reset Guide can solve your problem. Good Luck!