Ford E-Series: How To Reset TPMS Tire Pressure Sensor Light (2008-2021)
|Last Updated on November 25, 2020 by Nick
Ford E-Series: How To Reset TPMS Tire Pressure Sensor Light (2008-2021) – The Ford E series is a range of full-size vans from the Ford brand that was only available in North America. The Older versions were also known as the Econoline or Club Wagon.
The E-Series was the best-selling van in the United States as of 1980 (168,722 sales in 2007). The engines were much more powerful than European vans, so the last generation was only available with V6, V8, and V10 engines with up to 227 kW.
Table of Contents
Ford E-Series: How To Reset TPMS Tire Pressure Sensor Light (2008-2021)
Whenever tire pressure is adjusted, change a tire, or get it rotated you must carry out the TPMS reset procedure. Depending on the vehicle model year you have, here are a few ways to reset the TPMS on Ford E-Series (E150 E250 E350 E450):
E150 E250 E350 E450 (2008-2009)
Time needed: 7 minutes
You’ll need TPMS Relearn Tool to reset the Tire Pressure Monitoring System on this model. Follow these steps to do it:
- Park your vehicle
Stop the vehicle and turn off the engine
- Press and release the BRAKE pedal
Ensure fully pressed!
- Without starting the engine, turn the ignition key from OFF to the ON position 3 times with the ending in the ON position
If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position
- Press and release the BRAKE pedal
Ensure fully pressed!
- Turn OFF the ignition
Do not release the key!
- Turn the ignition key from OFF to the ON position 3 times with the ending in the ON position
If your vehicle has an ignition button, press the START/STOP button once to turn ON the ignition and then press the button again to turn OFF the ignition. Do this 3 times with the ending in the ON position
- You will hear a horn if you do it right
The horn will sound twice and the TRAIN LEFT FRONT TIRE message will appear on the screen
- Start from the driver side front tire, use the TPMS Relearn tool to reset the tpms sensor
Place the relearn tool against the tire sidewall, near the valve stem. Then press the button to activate the TPMS sensor
- Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire
A chirp horn will confirm that the sensor has been reset
- Turn off the ignition after you reset the last tire
The TIRE LEARNING message will disappear
- Adjust the tire pressure in all four tires recommended on the tire placard
Done!
E150 E250 E350 E450 (2010-2021)
Unlike the previous model, you can reset the TPMS without tools on this 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 model years. Follow the instructions below to restore TPMS:
- Drive your car for at least two minutes between 20 mph
- Stop the vehicle and turn off the engine
- Turn ON the ignition without starting the engine
- Turn the hazard flashers ON then OFF 3 times within 10 seconds (located behind the steering wheel)
- If you successfully enter the reset mode, the horn will sound indicating the TPMS matching process has started
- Start from the driver side front tire, remove the valve cap, and then increasing or decreasing the tire’s air pressure until a horn chirp sounds
- A horn chirp will confirm that the sensor has been reset
- Repeat the process for the passenger side front tire, passenger side rear tire, and the driver side rear tire
- Turn off the ignition after you reset the last tire
- Adjust the tire pressure in all four tires recommended on the tire placard
These instructions are based on the Ford E-Series owner’s manual. This procedure should apply to the fourth and fifth generations of Ford E150 E250 E350 E450 (2008 2009 2010 2011 2012 2013 2014 2015 2016 2017 2018 2019 2020 2021 model years). Hopefully, the article Ford E-Series: How To Reset TPMS Tire Pressure Sensor Light (2008-2021) can solve your problem. Good Luck!