2016-2021 Citroën Dispatch Tyre Pressure Sensor Light Reset Guide

Last Updated on January 19, 2021 by Nick

2016-2021 Citroën Dispatch Tyre Pressure Sensor Light Reset Guide – The Citroën Jumpy is a very light commercial vehicle that has been produced by Sevel Nord since 1995. In Great Britain, Ireland, and Australia, the model is sold as Citroën Dispatch.

The 3rd generation, which has been in production since 2016, was jointly developed by PSA and Toyota and is manufactured at the PSA plant in Valenciennes. With the Dispatch, Citroën now offers a special van model just like Peugeot with the Traveler.

2016-2021 Citroën Dispatch Tyre Pressure Sensor Light Reset Guide

The tyre pressure system must be initialized after an adjustment to the pressure of tyres, and after changing one or more wheels. Depending on your vehicle model year, here are a few ways to reset the tyre under-inflation detection system on 2016 2017 2018 2019 2020 2021 Citroën Dispatch:

With TPMS Button

Time needed: 7 minutes

Follow the instructions below if your vehicle is equipped with a Tyre Pressure Set button. Follow these steps to get started:

  1. Stop the vehicle and turn off the engine

    Tire pressure reset process cannot be done while the vehicle is moving.

  2. Adjust the cold tire pressure in all four tires recommended on the tire placard

    The tire placard located on the door panel

  3. Turn the ignition key to the “ON” position without starting the engine

    If your vehicle has an ignition button, press the START/STOP button without touching the brake pedal

  4. Look for the Tyre Pressure Set button and then press it for 3 seconds

    An audible signal will confirm that the sensor has been reset
    audi tpms tire pressure light reset

With Touchscreen

  • Make sure you have adjusted the tyre pressure recommended on the tire placard
  • Turn ON the ignition without starting the engine
  • Press the DRIVING / VEHICLE button
tpms tire pressure light reset
  • Select Under-inflation initialisation in the Driving Functions tab menu
  • Select Yes to execute the tyre pressure reset

With Audio Display

  • Stop the vehicle and adjust the tire inflation pressure recommended on the tire placard
  • Turn ON the ignition without starting the engine
  • Press the MENU button at the bottom of the audio display
  • Go to the CONFIGURATION menu by using the ⏪ or ⏩ button
low tyre pressure light reset
  • Press the OK button to enter the menu
  • Select the Define The Vehicle Parameters
  • Select the Driving Assistance
  • Select the Tyre Pressure
  • Select the Reinitialisation
  • When a confirmation message appears, select YES to execute the TPMS reset

These instructions are based on the Citroën Dispatch owner’s manual. This procedure should apply to the third generation of the Citroën Dispatch (2016 2017 2018 2019 2020 2021 model years). Hopefully, the article 2016-2021 Citroën Dispatch Tyre Pressure Sensor Light Reset Guide can solve your problem. Good Luck!