2017-2021 Citroën Berlingo TPMS Tyre Pressure Sensor Light Reset Guide

2017-2021 Citroën Berlingo TPMS Tyre Pressure Sensor Light Reset Guide – The Citroën Berlingo is a small Citroën van and passenger car. This car is designed in collaboration with PSA partner Peugeot.

The Peugeot version is called Partner, but the Ludospace variant has continued under the name Rifter since the third generation. The car is available in various commercial vehicle versions with corresponding body variations.

2017-2021 Citroën Berlingo TPMS Tyre Pressure Sensor Light Reset Guide

2017-2021 Citroën Berlingo TPMS Tyre Pressure Sensor Light Reset Guide

The tyre pressure system must be initialized after an adjustment to the pressure of tyres, and after changing one or more wheels. Depending on your vehicle model year, here are a few ways to reset the tyre under-inflation detection system on 2017 2018 2019 2020 2021 Citroën Berlingo:

With TPMS Button

Time needed: 7 minutes.

Follow the instructions below if your vehicle is equipped with a Tyre Pressure Set button. Follow these steps to get started:

  1. Stop the vehicle and turn off the engine

    Tire pressure reset process cannot be done while the vehicle is moving.

  2. Adjust the cold tire pressure in all four tires recommended on the tire placard

    The tire placard located on the door panel

  3. Turn the ignition key to the “ON” position without starting the engine

    If your vehicle has an ignition button, press the START/STOP button without touching the brake pedal

  4. Look for the Tyre Pressure Set button and then press it for 3 seconds

    An audible signal will confirm that the sensor has been reset
    peugeot low tyre pressure light reset

With Audio Display 1

  • Stop the vehicle and adjust the tire inflation pressure recommended on the tire placard
  • Turn ON the ignition without starting the engine
  • Press the MENU button at the bottom of the audio display
  • Go to the CONFIGURATION menu by using the ▲ or ▼ button
citroen low tyre pressure light reset
  • Press the OK button to enter the menu
  • Select the Define The Vehicle Parameters
  • Select the Tyre Inflation
  • Select the Reinitialisation
  • When a confirmation message appears, select YES to execute the TPMS reset

With Audio Display 2

  • Stop the vehicle and adjust the tire inflation pressure recommended on the tire placard
  • Turn ON the ignition without starting the engine
  • Press the MENU button to access the main menu
  • Go to the VEH CONFIG menu by using the ▲ or ▼ button and press the OK button to enter the menu
  • Select REINIT INFLAT
  • When a confirmation message appears, select YES to execute the TPMS reset

With Touchscreen Display

  • Stop the vehicle and adjust the tire inflation pressure recommended on the tire placard
  • Turn ON the ignition without starting the engine
  • Press the MENU button
citroen low tyre pressure light reset
  • Select the DRIVING menu by tap the screen
  • Select Under-Inflation Initialisation
  • Select Yes to execute the tyre pressure reset

These instructions are based on the Citroën Berlingo owner’s manual. This procedure should apply to the third generation of the Citroën Berlingo (2017 2018 2019 2020 2021 model years). Hopefully, the article 2017-2021 Citroën Berlingo TPMS Tyre Pressure Sensor Light Reset Guide can solve your problem. Good Luck!