2016-2020 GMC Yukon Change Engine Oil Minder Oil Life Light Reset

2016-2020 GMC Yukon Change Engine Oil Minder Oil Life Light Reset – The GMC Yukon is a sports utility vehicle of the American car manufacturer GMC. It is currently offered in the third generation and is based on the GMT-900 chassis of General Motors like the Chevrolet Tahoe and Suburban. The first generation of the Yukon on the GMT-400 chassis came in 1992 as a replacement for the GMC Jimmy K5 on the market. Like its predecessor, it was available as a three-door Yukon GT.

In 1998 GMC then introduced the top model, the GMC Yukon Denali, which was the luxury variant of the vehicle. This variant was introduced in order to be able to compete with the luxury model Lincoln Navigator from the Ford Group. In the same year still then additionally the Cadillac Escalade was offered on the same basis.

2016-2020 GMC Yukon Change Engine Oil Minder Oil Life Light Reset

2016-2020 GMC Yukon Change Engine Oil Minder Oil Life Light Reset

Time needed: 7 minutes.

When the remaining oil life is low, the Change Engine Oil Soon warning will appear on the display. The Oil Life display must be reset after each oil change. Follow the instructions below to reset the engine oil life system on your GMC Yukon:

  1. Turn the ignition key to the “ON” position without starting the engine

    If your vehicle has an ignition button, press and holds the Engine Start/Stop button for 5 seconds without touching the brake pedal

  2. Press the ◄ navigation button to access the cluster applications

    The button is located on the steering wheel
    change engine oil life light reset

  3. Find and select the INFO page

    Press the ✓ button to enter the menu

  4. Scroll down to the “REMAINING OIL LIFE” menu

    Use the ▲ or ▼ button to scroll down

  5. Press and hold the ✓ button until the oil life display changes to 100 percent

    On some models, a confirmation message will appear on the display, select YES to confirm

  6. Turn the ignition off and start the engine to verify the indicator has been reset.

    Done!

Method 2:

The oil life system can also be reset as follows:

  • Turn the ignition to ON position without starting the engine.
  • Fully press the gas pedal to the floor 3 times within five seconds.
  • Turn the ignition off and start the engine to verify the indicator has been reset.

For more details, please watch the following video:

These instructions are based on the GMC owner’s manual. This procedure should be work on the fourth generation of GMC Yukon (2015 2016 2017 2018 2019 2020 model years). Hopefully, the article of 2016-2020 GMC Yukon Change Engine Oil Minder Oil Life Light Reset can solve your problem. Good Luck!

Name
Comment