2015 Jeep Renegade Oil Change Due Minder Light Reset
2015 Jeep Renegade Oil Change Due Minder Light Reset – Jeep Renegade adds to the list of vehicles in the class sports utility vehicle (SUV) which can be visited for those who are looking for a vehicle masculine. The existence of this car revealed at the Geneva Motor Show 2014 event and is ready to compete with similar cars, like the Kia Soul and Jeep Grand Cherokee.
Jeep Renegade is available in two engine options in the United States; with a 1.5-liter engine with 160 HP, and a four-cylinder engine with a capacity of 2.4 liters 184 HP catapult. In addition to engine options, Fit-Chrysler also provides the option for the system drive with four-wheel drive (4WD); Active Drive and Active Drive Low who has traction control, Auto, Snow, Sport, and Sand.
2015 Jeep Renegade Oil Change Due Minder Light Reset
Time needed: 7 minutes.
When engine oil needs to replace, Oil Change Required or Change Oil message will appear on the display. The engine oil life system must be reset after performed the maintenance service or change the engine oil on your vehicle. Follow the instructions below to reset the Oil Change Due Light on your Jeep Renegade:
- Stop the vehicle and turn the ignition switch to the RUN position without starting the engine
If your vehicle has an ignition button, press the ENGINE START STOP button twice without touching the brake pedal
- Fully depress the GAS PEDAL slowly three times within 10 seconds
Make sure to depress the pedal all the way down
- Turn the ignition off and start the engine to verify the indicator has been reset.
Repeat this procedure, if the message still illuminates when you start the engine.
For more details, please watch the following video:
These instructions are based on the Jeep owner’s manual. This procedure should be work on the first generation of Jeep Renegade (2015 2016 2017 2018 2019 2020 model years). Hopefully the article of 2015 Jeep Renegade Oil Change Due Minder Light Reset useful for you. Good Luck!
It doesn’t work. I work in a Jeep service dept. Both the Support desk “STAR” and my TA have informed me the only way to reset the oil indicator is through the IPC, miscellaneous function. Ya got to plug them in take my word for it.
What diagnostic tool is able to reset the service light?
I have a 2016 with push button start and it does work. The directions are wrong. You press the start button once, not twice as noted. Then follow the rest of the procedure.